Install The Battery; Install The Lights - Craftsman 139.53918D Owner's Manual

INSTALLATION STEP 7
Install the Battery
• Make sure motor unit is unplugged.
• Using a Phillips head screwdriver, remove the battery cover on
the motor unit.
• Partially insert battery into motor unit with terminals facing
out.
• Oonnect the red (+) and black (-) wires from motor unit to
corresponding terminals on battery.
• Verify the battery wires are seated in the channel.
• Replace battery cover.
ALWAYSwear protective gloves and eye protection when
changing the battery or working around the battery
compartment.
_i_e ry Cover
INSTALLATION STEP 8
Install the Lights
• Press the releasetabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
• Install up to a 100 watt maximum light bulb in each socket.
Light bulb size should be A19, standard neck only. The lights
will turn ON and remain lit for approximately 4-1/2 minutes
when power is connected. Then the lights will turn OFF.
• Reversethe procedure to close the lens.
• If the bulbs burn out prematurely due to vibration, replacewith
a garage door opener bulb. Use A19, standard neck garage
door opener for replacement.
NOTE: Use only standard light bulbs. The use of short neck or
speciality light bulbs may overheat the endpanel or light socket.
To prevent possible OVERHEATING of the endpanel or light
socket:
• DONOT use short neck or specialty light bulbs.
• DONOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DONOT use bulbs larger than IOOW.
• ONLY use A19 size bulbs.
1O0 Watt
Standard Light Bulb
Release Tab /
Hinge
100 Watt (Max)_'_
Standard Light Bulb _...._
18