Specifying The Scan Size Of The Original - Sharp MX-2300N Guide Scanner Manual

SPECIFYING THE SCAN SIZE OF THE ORIGINAL

If the original is a non-standard size or you wish to change the scan size, touch the [Original] key to specify the original
size manually. Place the original in the document feeder tray or on the document glass and follow the steps below.
Specifying the size using paper sizes
USB Mem. Scan
Mode Switch
Exposure
Image
Settings
200X200dpi
Resolution
File Name
1
Auto
Original
(1)
USB Mem. Scan
Scan Size
Original
Auto
2
2-Sided
Booklet
2-Sided
Tablet
USB Mem. Scan
Original
Auto
Manual
Manual
3
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. (When the automatic document feeder is not installed, the [Long Size] key does not appear.) The maximum
length that can be scanned is 800 mm (31-1/2") (the maximum width is 297 mm (11-5/8")).
• To specify an inch size for the scan size, touch the [AB
scan size.
USB Mem. Scan
Scan Size
Original
4
2-Sided
Booklet
2-Sided
Tablet
When [Long Size] is selected, the two-sided scanning setting and send size cannot be changed. In addition, scanning will
take place in Mono 2 mode.
Auto Mono2/Auto
Colour Mode
TIFF/JPEG
File Format
A4
Special Modes
(2)
100%
Send Size
A4 Auto
Image Orientation
AB Inch
A5 B5R 1 / 2 B4
A5R A4 1 / 2
A3
B5 A4R Long Size
Standard Size Size Input
(1)
100%
Send Size
Auto
B5
Image Orientation
Display the original settings screen.
(1) Touch the [Image Settings] key.
Special Modes
(2) Touch the [Original] key.
The automatically detected size appears at the top of the
[Original] key.
Touch the [Scan Size] key.
OK
Specify the scan size.
OK
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
(2)
Inch] key to highlight the [Inch] side and then specify the
Touch the [OK] key.
OK
55