Table of Contents
Advertisement
Available languages
Available languages
About the controls with
temperaturesettings.
(for other models, see next page)
GEAppl_nce_com
t
NOTE,"Therefrigerator is shipped with protective film covering the temperaturecontrols.
If this film was not removed during installation, remove it now
The temperature controls are preset in the factory at 37°1:for the refrigerator compartment
and #OFfor the freezer compartment. Allow 24 hours for the temperature to stabilize to the
preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly from
the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.
Changing the Temperature
To change the temperature,
press and release the
WARMER
or COLDER pad. The
SETlight
will c(:,me
on and
the
display
will show
the
set temperature.
To change
the
teml)eratm'e,
tn l) either
the
WARMER
or COLDER pad until
the desired
teilll)erattlre
is displayed,
Refl'igerator
teml)erattlres
can be a(!iusted
between
34°F and
47°F and
the
fl'eezer
teInI)eratures
can be ac!iusted
between
-6°F
and +8°E
Once
the desired
temperature
has been
set,
the
temperatm'e
display
will return
to the
actual
refi'igei'ator
and
fl'eezer
teml)erattlres
afiei" 5
seconds,
Several
ac!iustments
may be required,
Each time you a(!just controls,
allow 24 horns fiw the
refl_igerator
to reach
the temperatm'e
you have set.
Toturn the cooling system off, tnI) the WARMER pad
fro" either
the refl_igerator
or the fl'eezer
until the
display shows OFF.To turn the unit back on, press the
COLDERpad fl)r either
the refl_igerator
or fl'eezei;
The SErlight
will illuminate
on the side you
selected.
Then
press the COLDERpad again
(on the
side where
the SETlight is illuminated)
and it will
go to the preset points
of O°Fflw the fi'eezer
and
37°Ffi)r the refl-igeratm;
Setting
either
or both
controls
to OFFstops cooling
in both the fi'eezer
and refi-igerator
compartments,
but does not shut
off electrical
power
to the refl_igeratm;
Performance A# Flow System
The
Pedbm_an('e
_Mr Flow
System
is designed
to
maMmize
temperature
control
in the
refl_igerator
and fl'eezer
conq)artmei_ts.
This
tmique
special
teatm'e
consists
of the
_dr Tower
along
the
back
wall of the
refrigerator
and the _Mr Tmmel
on the
bottom
portion
of the
fl'eezer
rear
wall. Placing
fi)od
in fl'ont
of the lou\'e_s
on fl_ese components
will not affect
i)eHbm_ance.
Advertisement
Table of Contents
