GE Model 20 Owner's Manual And Installation Instructions page 28

Installation Instructions
REVERSING THE DOOR SWING
(cont.)
[] TRANSFER REFRIGERATOR
DOOR HANDLE TO RIGHT
[]
In order to correctly install the
handle on the right side, place
a small piece of masking tape
near the top of the handle
before removing.
Grasp the handle tightly with both hands
and slide the handle up (this may require
some force). The keyhole slots on the
back of the handle allow the handle to
separate from the mounting screws.
Screws
mounted
on door
\
Keyhole slots
on back of handle
[] Using a 3/8" or 10 mm socket driver,
remove the handle mounting screws.
[] Carefully pry off the logo badge and plug
button. Remove a layer of adhesive and
backing to expose new adhesive. Install
logo badge and plug button on left side.
[] Install the handle mounting screws on
the right side.
[]
[]
TRANSFER REFRIGERATOR
DOOR HANDLE TO RIGHT (cont.)
Holding the handle so the masking tape
is at the bottom, align keyhole slots on
the top and bottom of the back of the
handle with the screws mounted on the
front of the door. Press the handle
against the door front, making sure that
the screws go into the keyhole slots.
Grasping the handle with both hands,
press it firmly against the front of the
door and slide the handle down. This
may require some force.
Keyhole slots
on back of handle
Screws
[ mounted
on door
28