Extracting A Device Configuration - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Configuration Manual

Appendix D MiniMax Command Summary

Extracting a Device Configuration

78-13124-05
3. Use the terminal emulation application's commands to initiate sending the
image file via xmodem.
The image file transfer can take up to an hour depending on
Note
the baud.
When the transfer is complete, you should see a display similar to the
4.
following on the SSL device's console,:
--Download complete--
Image address:
Image length: 1951826
Signed: yes
Image type: PHR/PHX file
csid: 0x460313d8
version: 0x00004000
system: 0x00000001
product: 0x00000005
arch: 0x00000007
type: 0x00000006
use zap to save to flash
5. Enter the following commands to save the image and restart the device.
>>zap
>>boot
Messages are written to the console, indicating necessary files are written.
6.
The device will reboot into the serial console configuration manager.
The best way to restore a device configuration is to use a previously saved
configuration file using commands in the configuration CLI. If you have not saved
the configuration previously and the device has entered MiniMax, you can list the
contents of the configuration file for capture.
Set up the terminal emulation program to capture text.
1.
2. Enter the following command to list the configuration to the window.
>> cat /flash/startup-config
Cisco 11000 Series Secure Content Accelerator Configuration Guide
0x3a56350
Examples
D-7