Table of Contents
Advertisement
6. Once the grinder is in place, plug
the grinder cord into the AC receptacle
inside the base of the
coil the remaining cord in the space
under and behind the grinder.
(see photo #6).
7. Slide the cast metal cover into
place from the rear, taking care to see
that the front "fingers" lock into correct
position.
(see photo #7).
8. Replace the Phillips screw in the
rear of the casting to secure the cast-
ing in place.
9. Install the
ESATTO
retainer by placing the slot over the
blade of the knob, rotate the knob until
the retainer is vertical, then slide the
retainer into the hole in the base of the
. The knob will then be held
ESATTO
TM
in the ON position.
(See photo #8 & #9).
10. Plug the
ESATTO
power supply.
, and
ESATTO
TM
timer knob
TM
into to an AC
TM
6
Photo #6
Photo #7
Photo #8
Photo #9
Advertisement
Table of Contents
