Installation; Installation Procedure - Brother PE-Design 6.0 Instruction Manual

PeDesignV6Eng.book Page 7 Thursday, July 8, 2004 11:59 AM

Installation

Installation procedure

The installation procedure is different depending on whether the full version or an upgrade of the software is
being installed. Be sure to perform the installation procedures listed below.
Installing version 6.0 (full version)
[STEP 1] Installing the software
[STEP 2] Installing the driver for the card writer module
Upgrading from version 1.0 through 4.0
[STEP 1] Installing the software
[STEP 2] Installing the driver for the card writer module
Upgrading from version 5.0 or 5.01
[STEP 1] Installing the software
[STEP 2] Installing the driver for the card writer module
[STEP 3] Upgrading the USB card writer module
Upgrading from version 5.02 or later
[STEP 1] Installing the software
b
Memo:
When upgrading from version 5.02 or later, STEP 2 is not performed.
[STEP 3] Upgrading the USB card writer module
a
Note:
• If the installation is interrupted or not performed as described, the software will not be installed correctly.
• Before turning on the computer, be sure to disconnect the USB card writer module. If the
computer is turned on while the card writer is connected, the installation may not be completed
correctly when upgrading from version 5.0 or 5.01.
• In order to upgrade the USB card writer module, you must be able to connect to the Internet. If you
cannot connect to the Internet, contact your nearest service representative.
Before Use
c
page 8
c
page 10
c
page 8
c
page 10
c
page 8
c
page 10
c
page 12
c
page 8
c
page 12
7