Logging In To The Ilo Mp - HP rp4410 Installation Manual

Installing the System
Console Setup
IMPORTANT Do not use hpterm and vt100 terminal types at the same time.
There are many different emulation software applications. Consult the help section of your
emulation software application for instructions on how to configure the software options.
Step 3. Use Table 1-14 to determine the required connection components and the ports used to connect the
server to the console device.
Step 4. Connect the cables.
a. Connect the DB-9 end of the RS-232 serial port female-to-female cable to the console RS-232
serial port.
b. Connect the other end of the DB-9 female-to-female cable to the console device.
Step 5. Start the emulation software on the console device.
Step 6. Log in to the iLO MP. See "Logging In to the iLO MP" on page 82.
Step 7. At the
MP Main Menu
Step 8. At the command mode prompt, enter LS and press
configuration values. Write down the default values or log the information to a file for future
troubleshooting.
Step 9. Use the LC command to disable DHCP.
a. From the LC command menu, type D and press
b. Follow the instructions on the screen to change the DHCP status from Enabled to Disabled.
c. Enter XD -R to reset the iLO MP.
Step 10. Use the LC command to enter information for the IP address, host, subnet mask, gateway
parameters, and so on.
Step 11. Enter XD -R to reset the iLO MP.
Step 12. After the iLO MP resets, log in to the iLO MP again and enter CM at the MP> prompt.
Step 13. Enter LS to confirm that DHCP is disabled and display a list of updated LAN configuration
settings.

Logging In to the iLO MP

To log in to the iLO MP, follow these steps:
Step 1. Access the iLO MP using the LAN, RS-232 serial port, telnet, SSH, or Web method. The iLO MP
login prompt displays.
Step 2. Log in using the default the iLO MP user name and password (Admin/Admin). The
screen displays.
TIP
82
, enter CM and press
For security reasons, HP strongly recommends that you modify the default settings
during the initial login session. See "Modifying User Accounts and Default
Password" on page 83.
to select command mode.
Enter
. The screen displays the default LAN
Enter
.
Enter
MP Main Menu
Chapter 1