Table of Contents
Advertisement
4. Turn on the power. This causes the Bridge Satellite Cradle power indicator lamp to
light in red.
5. Making sure that their two IR ports come into contact with each other, place the
Handheld Terminal onto the Bridge Satellite Cradle. This causes the Bridge Satellite
Cradle power indicator lamp to light in green.
• If the system is operating normally and data communication is enabled, the system
status indicator lamp lights in green.
• The communication indicator lamp flashes in green when data communication starts.
When charging is initiated, indicator 2 on the DT-X10 lights up in red. When charging
has been completed, indicator 2 on the DT-X10 changes color from red to green.
Important!
• A high-sensitivity communication element is used during IR data
communication.
In order to ensure successful communication, avoid using cellular phones or
other devices that emit radio wave in the area where you are performing IR data
communication.
If you need to use such a device, move away from the communicating Handheld
Terminals. In case of a cellular phone, keep it at least 30cm (
• Take care to avoid allowing the Bridge Satellite Cradle power contacts to
become connected to each other, which creates a short.
Shorting the power contacts can damage the Bridge Satellite Cradle.
E-40
DT-X10_E_P37_52.p65
40
11
7 7 7 7 7
⁄ ⁄ ⁄ ⁄ ⁄
"
) away.
8 8 8 8 8
05.4.1, 11:04 AM
Advertisement
Table of Contents
