Table of Contents
Advertisement
Using the Laser Scanner (Laser Scanner models only)
1. After turning on the power, position the laser scanner close to a bar code and then
press the trigger key.
2. The laser emits light and scans the bar code. If scanning is completed normally,
Indicator 1 displays a green light and a buzzer sounds. If the bar code was not
scanned properly, Indicator 1 indicates a red light.
Important!
• If you are unable to scan a bar code, try changing the angle at which the scanner
is held or distance from the scanner to the bar code, and then try scanning
again.
• This Handheld Terminal is capable of scanning bar codes at a distance of
about 40-300 mm (1
is possible may vary according to the type of bar code.
• The laser scanner models are not available in the USA and Canada.
DT-X10_E_P14_36.p65
5
7
/
"-11
/
"). Furthermore, the distance at which scanning
8
8
29
05.4.1, 11:04 AM
E-29
Advertisement
Table of Contents
