HP D7171A - NetServer - LPr Upgrade Manual page 78

Chapter 7
b. Remove the PCI slot cover. (See Figure 7-2.)
c. Insert the accessory board.
CAUTION
Do not bend the accessory board to install it into the slot. If
the PCI board is full-length, the PCI board guide at the rear of
the PCI slot is used to hold the board in place. The PCI board
guide latch prevents the board from moving when attaching
cables to the board externally.
72
5b. Remove the
PCI slot cover.
Figure 7-2. Remove PCI Slot Cover
Finishing the Assembly