Disassembling The Lxr 8000; Disconnect Cables, Remove Power Supplies, And Extend Rack - HP D7171A - NetServer - LPr Upgrade Manual

3 Disassembling the LXr 8000

This chapter describes how to complete the following steps to disassemble the
LXr 8000.

Disconnect cables, remove power supplies, and extend rack.

Remove bezel, control panel, and covers.
Remove memory boards.
Remove fans and fan cage.
Remove processor tray.
Remove I/O tray.
Remove midplane board and center support.
l
Apply gaskets to chassis.
CAUTION
Disconnect Cables, Remove Power Supplies, and
Extend Rack
CAUTION
1. If you have not already done so, close all applications, log off all users, and
shut down the operating system.
2. Turn off the NetServer and monitor.
3. If necessary, label all external cables before you disconnect them.
4. Disconnect all telephone cables and power cables.
5. Disconnect all external cables such as the keyboard, mouse, monitor, LAN,
SCSI, and so on. All cables will be reused in NetServer LXr 8500.
Do not proceed until you have followed the instructions in
Chapter 2 to back up your data.
Put on the anti-static wrist strap and place an anti-static mat on
a firm surface near the system. Connect the strap and mat to
an unpainted metal surface on the system chassis.
19