Finishing The Assembly; Add Remaining Processors - HP D7171A - NetServer - LPr Upgrade Manual

7 Finishing the Assembly

Now that you know the NetServer LXr 8500 boots, you can finish the assembly.
This chapter provides instructions on:
l
Adding the remaining processors
l
Installing accessory boards on the I/O baseboard
l
Installing the top cover and bezel.
NOTE

Add Remaining Processors

CAUTION
1. Open the processor cage cover on the LXr 8500.
2. Remove each remaining processor module from the LXr 8000 and insert it
into the LXr 8500 as follows:
a. From the front of the NetServer LXr 8500, locate the left processor
cage.
b. Starting with the leftmost terminator in the left processor cage, remove
one terminator for each processor you plan to install into the LXr 8500.
c. Remove each processor module from the LXr 8000 and turn it 180
before inserting it into the LXr 8500.
d. Make sure that the retaining latches on top of the processor module are
open (pointing straight up). Slide the processor module into the
leftmost open slot in the processor cage, and rotate the retaining latches
into the closed position.
e. Fully install processor modules on the left processor cage before
installing and using the right processor cage. The left processor cage
must be fully loaded with four processor modules before you install
If you removed the NetServer from the rack, see the HP
NetServer LXr 8500 Installation Guide for instructions on
reinstalling it in the rack.
Be sure the NetServer power is off and the power cord is
disconnected before you proceed with the instructions in this
chapter.
o
69