Administration Settings
Factory Defaults
STEP 1
STEP 2
STEP 3
Factory Defaults
Cisco SPA100 Series Phone Adapters Administration Guide
Traceroute Test
Use the Administration > Diagnostics > Traceroute page to view the route
between the ATA and a destination.
To open this page: Click Administration in the menu bar, and then click
Diagnostics > Traceroute Test in the navigation tree.
Enter the IP address or domain name of the destination.
Click Start to Traceroute to start the test. The results appear on the page and are
refreshed every 5 seconds. During the test, you can click Stop to abandon the test.
The results display up to 30 hops.
Click Close to close the results and display the Traceroute Test form.
Use the Administration > Factory Defaults page to reset the ATA to the default
configuration. Alternatively, press and hold the RESET button for 20 seconds. All
user-changeable non-default settings will be lost. This may include network and
service provider data.
To open this page: Click Administration in the menu bar, and then click Factory
Defaults in the navigation tree.
You can perform the following tasks:
•
Restore Router Factory Defaults: Choose Yes to remove any custom data
(router) settings that you have configured. The default settings will be
restored when you click Submit.
•
Restore Voice Factory Defaults: Choose Yes. to remove any custom
settings that you configured on the Voice pages of the configuration utility.
The default settings will be restored when you click Submit.
5
127