Table of Contents
Advertisement
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
JWAC Port Settings
This window is used to configure JWAC port settings for the Switch.
To view this window, click Security > Japanese Web-based Access Control (JWAC) > JWAC Port Settings as
shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port / To Port
State
Max Authenticating
Host (0-100)
Aging Time (1-1440)
Block Time (0-300)
Idle Time (1-1440)
Figure 8-43 JWAC Port Settings Window
Description
Select the unit you want to configure.
Use the drop-down menus to select a range of ports to be enabled as JWAC ports.
Use this drop-down menu to enable the configured ports as JWAC ports.
Enter the maximum number of host process authentication attempts allowed on each
port at the same time. The default value is 100.
Enter the time period during which an authenticated host will remain in the
authenticated state. Tick the Infinite check box to never age out the authenticated host
on the port. The default value is 1440.
Enter the period of time that a host will be blocked if it fails to pass authentication. The
default value is 60.
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. The default value is Infinite. To change this value, un-tick the
Infinite check box and enter a value between 1 and 1440 minute(s). Tick the Infinite
check box to indicate the Idle state of the authenticated host on the port will never be
checked.
355
Advertisement
Table of Contents
