Wireless Repeating Function - NETGEAR JWNR2000v1 User Manual

To set up a wireless network using WDS,
• Both APs must use the same SSID, wireless channel, and encryption mode (see
Appropriate Wireless Security" on page 2-1
Protected Setup)" on page
• Both APs must be on the same LAN IP subnet. That is, all the AP LAN IP addresses are in the
same network.
• All LAN devices (wired and wireless computers) must be configured to operate in the same
LAN network address range as the APs.
• If you make changes in the Wireless Settings screen, click Apply so that they take effect.

Wireless Repeating Function

You can view or change wireless repeater settings for the wireless router. From the main menu of
the browser interface, under Advanced, click Wireless Repeating Function to display the
Wireless Repeating Function screen.
Figure 4-8
The wireless router supports two modes of the wireless repeating function, and allows you to
control wireless client association:
• Wireless Repeater. The wireless router sends all traffic from its local wireless or wired
computers to a remote AP. To configure this mode, you must know the MAC address of the
remote parent AP.
Customizing Your Network Settings
NETGEAR Wireless-N 300 Router JWNR2000 User Manual
t
he following conditions must be met for both APs:
or "Using WPS Push Button Connect (Wi-Fi
2-13).
v1.0, February 2010
"Choosing
4-13