Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual page 49

b zz
I
b
I
Serial Number
Enter transmitter's 7- digit serial number via RF
learning or manually.
[#] = return to (1A) prompt and reject
whatever serial number entries have been
made.
[✻] = return to (1A) prompt (if a valid serial
number has been enrolled, "L" is
displayed and the serial number will be
copied into EEROM and the last serial
entered buffer.
Note: For zones 26, 30, 34 and 38 only BR
type devices can be used.
F
Delete Serial Number
0 = discard the delete request
1 = confirm requested delete
Note: Entering a "9" at prompt (1A) will cause
the panel to return to prompt (1A)
regardless of the confirmation answer.
Note: In Enhanced Sequential Learn Mode, 4 button type keys will always be learned simultaneously. They will be stopped at the 4 button
boundaries of 26, 30, 34 and 38, provided the zone is free of a serial number. If the first zone of the key has a serial number learned,
the remaining keys cannot be programmed in sequential learn mode. In addition, if the zone has not been set up (duplicate loop,
missing zone type, etc.) only entries 0 (skip to the next zone) and 4 (copy the key template) will be allowed.
LYNXR-2 Series Installation and Setup Guide
✻ 83 Enhanced Sequential Mode
This prompt can be used to enroll the transmitter serial number via RF transmission
or manually. If using the RF Learning Mode there is no need to manually enter a
serial number. Proceed directly to RF Learning. Upon entering the Serial Number
mode, the Zone Descriptors will be announced.
Note: BR type devices can be enrolled only by transmission from BR devices. Likewise,
UR and RF devices can only be enrolled by transmission from a UR or RF device
RF Learning - Two (2) transmissions (2 key depressions) at least five seconds apart,
will be required for BR type or four (4) transmissions (fault, restore and fault, restore)
for UR or RF type. If the learned serial number has a different loop number than that
entered in ✻56 the system will announce the Voice Descriptor, if it is programmed,
followed by two beeps and will return to Prompt (1A) and "L" will be displayed.
If the loop number captured by RF transmission and that entered in ✻56 mode match,
the system will announce the Voice Descriptor, if it is programmed, followed by three
beeps and return to Prompt (1A) and "LC" will be displayed.
transmissions are needed for confirmation.
Manual Entry - Enter the 7-digit serial number printed on the transmitter. If you
enter an incorrect digit, press the [#] key to backup to prompt (1A) and start over.
When all 7 digits are entered, press the [✻] key. If less than 7 digits are entered, the
keypad will emit a single long beep and return to the (1A) prompt without displaying
the "L".
If more than 7 digits have been entered, the first 6 digits will be saved along with the
last digit that was entered (entering 123456789 yields the serial number 1234569).
Note: The system will return to prompt (1A) if an entry is not made within 52 seconds.
This function deletes only the serial number.
Entering a "9" at prompt (1A). Confirmation of the delete request will cause deletion
of the serial number pertaining to the zone being programmed.
- 49 -
No additional