Cisco ROUTER-SDM-CD User Manual page 139

Chapter 6 Edit Interface/Connection
IP Address
Operating Mode
Note
OL-4015-12
If you are editing an existing connection, this field is disabled. If you need to
change this value, delete the connection and re-create it using the value you need.
Choose how the router will obtain an
Static IP address—If you choose Static IP Address, enter the IP address and
•
subnet mask, or network bits in the fields provided. For more information, see
IP Addresses and Subnet
Dynamic IP address—If you choose Dynamic, the router will lease an IP
•
address from a remote DHCP server. Then enter the name or IP address of the
DHCP server.
• Unnumbered IP address—Choose IP Unnumbered if you want the interface
to share an IP address that has already been assigned to another interface.
Then choose the interface whose IP address this interface is to share.
IP Negotiated—This interface will obtain an IP address using PPP/IP Control
•
Protocol (IPCP) address negotiation.
Choose the mode that the ADSL line should use when training.
If the Cisco IOS release you are running on the router does not support all five
operating modes, you will see options only for the operating modes supported by
your Cisco IOS release.
annexb—Standard Annex-B mode of ITU-T G.992.1.
•
• annexb-ur2—ITU-T G.992.1 Annex-B mode.
auto—Configure the Asymmetric Digital Subscriber Line (ADSL) line after
•
autonegotiating with the digital subscriber access line multiplexer (DSLAM)
located at the central office.
etsi—European Telecommunications Standards Institute mode.
•
multimode—Mode chosen by the firmware for the best operating condition
•
on digital subscriber line (DSL). The final mode can be either ETSI mode or
standard Annex-B mode depending on the current DSLAM setting.
Cisco Router and Security Device Manager 2.5 User's Guide
IP address for this link.
Masks.
Connection: ADSL over ISDN
6-29