Chapter 42
Viewing Router Information
QoS
Interface—IP/Mask—Slot/Port—Description
View Interval
OL-4015-12
The
QoS
Status window allows you to monitor the performance of the traffic on
QoS configured interfaces (see
window also allows you to monitor bandwidth utilization and bytes-sent for
interfaces with no QoS configuration. Monitoring inbound traffic on QoS
interfaces shows the statistics only at a protocol level. Protocol-level statistics for
non-QoS interfaces are collected for traffic in both directions.
This window allows you to monitor the following statistics:
Bandwidth utilization for Cisco SDM defined traffic types
•
Bandwidth utilization per class under each traffic type
–
Bandwidth utilization for protocols under each class
–
Bandwidth utilization is shown in Kbps.
Total incoming and outgoing bytes for each traffic type
•
Incoming and outgoing bytes for each class defined under the traffic type
–
Incoming and outgoing bytes for each protocol for each class
–
If the value is more than 1,000,000, then the graph may show the bytes as a
multiple of 10^6. If the value is more than 1,000,000,000, then the graph may
show the bytes as a multiple of 10^9.
Packets dropped statistics for each traffic type
•
This area lists the interfaces with associated QoS policies, their IP addresses and
subnet masks, slot/port information if applicable, and available descriptions.
Select the interface that you want to monitor from this list.
Select the interval at which statistics should be gathered:
Now—Statistics are gathered when you click Start Monitoring.
•
Every 1 minute—Statistics are gathered when you click Start Monitoring,
•
and refreshed at 1-minute intervals.
Cisco Router and Security Device Manager 2.5 User's Guide
Associating a QoS Policy With an
Traffic Status
Interface). This
42-25