Using The Startup Wizard - Cisco AIR-WLC4402-50-K9 Installation And Configuration Manual

Using the Startup Wizard

Using the Startup Wizard
The first time you power up a controller with a new factory Operating System configuration, use the
Startup Wizard to do the following:
Use the information you collected in
Note
Step 1 Enter the system (controller) name, up to 32 printable ASCII characters.
Enter the administrative username and password, each up to 24 printable ASCII characters. The default
Step 2
administrative user login and password are admin and admin, respectively.
The Service-Port Interface and Management Interface must be on different subnets.
Note
Enter the Service-Port Interface IP configuration protocol (none, or DHCP). If you do not want to use
Step 3
the Service port or if you want to assign a static IP address to the Service port, enter none.
If you entered none, enter the Service-Port Interface IP address and netmask on the next two lines. If
Step 4
you do not want to use the Service port, enter 0.0.0.0 for the IP address and netmask.
Enter the Management Interface (refer to Management Interface in the Product Guide) IP address,
Step 5
netmask, default router IP address, and optional VLAN identifier (a valid VLAN identifier, or '0' for
untagged).
Step 6 Network Interface (Distribution System) Physical Port number:
* 4402: 1 -2 for front panel GigE port
* 4404: 1 - 4 for front panel GigE port
Enter the IP address of the default DHCP Server that will supply IP addresses to clients, the Controller
Management Interface, and optionally to the Service Port Interface.
Enter the LWAPP Transport Mode, LAYER2 or LAYER3 (refer to Layer 2 and Layer 3 Operation in the
Step 7
Product Guide).
When you select Layer 3 LWAPP operation, you must also create an AP-Manager interface.
Note
Enter the Virtual Gateway IP address; one fictitious, unassigned IP address (such as 1.1.1.1) to be used
Step 8
by all Controller Layer 3 Security and Mobility managers.
Enter the Controller Mobility Group (RF Group) Name.
Step 9
Enter the WLAN 1 SSID, or Network Name. This is the default SSID that the access points use when
Step 10
they join a controller.
Allow or disallow static IP addresses for clients. (Yes = clients can supply their own IP address. No =
Step 11
clients must request an IP address from a DHCP server.)
If you are configuring a RADIUS server now, enter YES, and the RADIUS Server IP address,
Step 12
communication port, and Secret. Otherwise, enter NO.
Enter the Country Code for this installation. Type 'help' to list the supported countries, and refer to
Step 13
Configuring the Cisco Wireless LAN Controller and Cisco WLAN Solution Supported Country Codes in
the Product Guide.
Independently enable and/or disable the 802.11b, 802.11a, and 802.11g Cisco 1000 Series lightweight
Step 14
access point networks.
Cisco 4400 Series Wireless LAN Controllers - Installation and Configuration Guide
18
"Collecting Required Tools and
Installation and Configuration
Information" for this step.
78-17157-01