Inserting A Pci Card; Changing The Bracket - Cisco AIR-CB21AG-W-K9 Installation And Configuration Manual

Chapter 1 Product Overview and Installation
Step 4 If the Found New Hardware Wizard window appears, click Cancel.
Note
Go to the
Step 5

Inserting a PCI Card

You must perform the following procedures in the order listed below to insert a PCI card:
•
•
•
•

Changing the Bracket

The PCI card is shipped with a full-profile bracket attached. If the PC into which you are inserting the
PCI card requires the card to use a low-profile bracket, follow these steps to change brackets.
Remove the two screws that attach the bracket to the card. See
Step 1
Figure 1-4
1
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows Vista
OL-16534-01
If you do not click Cancel, the wizard will attempt to install software for the client adapter but
will be unable to find it.
"Installing the Client Adapter Driver and Software" section on page
If required, change the bracket (see the
Insert the card (see the "Inserting the Card" section on page
Assemble the antenna (see the
Mount the antenna (see the
Changing the PCI Card Bracket
1
1
Bracket screws
"Changing the Bracket" section on page
"Assembling the Antenna" section on page
"Mounting the Antenna" section on page
Inserting the Client Adapter
1-18.
1-11).
1-12).
1-13).
1-14).
Figure 1-4.
1-11