Cisco AIR-CB21AG-W-K9 Installation And Configuration Manual page 27

Chapter 1 Product Overview and Installation
Follow the steps below to position the PCI card's antenna on a flat horizontal surface or to mount it to a
wall.
Perform one of the following:
Step 1
If you want to use the antenna on a flat horizontal surface, position the antenna so it is pointing
•
straight up. Then go to Step 7.
If you want to mount the antenna to a wall, go to Step 2.
•
Drill two holes in the wall that are 1.09 in. (2.8 cm) apart.
Step 2
mounting holes on the bottom of the antenna base.
Figure 1-7
Tap the two supplied wall anchors into the holes.
Step 3
Step 4 Drive the two supplied screws into the wall anchors, leaving a small gap between the screw head and the
anchor.
Position the mounting holes on the bottom of the antenna base over the screws (see
Step 5
down to lock in place.
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows Vista
OL-16534-01
Bottom of Antenna Base
1.09 inches
Inserting the Client Adapter
Figure 1-7 shows the distance between the
Figure 1-8) and pull
1-15