Chapter 6
Connecting Interface Cables on the ASA 5500, ASA 5510, ASA 5520, and ASA 5540 Platforms
This procedure does not apply to the 4GE SSM. See
Note
page 6-6
To connect to an SSM, perform the following steps:
Connect one RJ-45 connector to the management port on the SSM, as shown in
Step 1
Figure
Connect the other end of the RJ-45 cable to your network devices.
Step 2
Figure 6-3
1
Connect to Ethernet ports to be used for network connections.
Step 3
a.
b.
78-19186-01
for information about connecting to the 4GE SSM.
6-3.
Connecting to the SSM Management Port
SSM management port 2
Connect the RJ-45 connector to the Ethernet port.
Connect the other end of the Ethernet cable to your network device, such as
a router, switch or hub.
Connecting to a 4GE SSM,
1
2
RJ-45 to RJ-45 cable
Cisco ASA 5500 Series Getting Started Guide
Connecting to SSMs
6-5