Chapter 15
Configuring the 4GE SSM for Fiber
Setting the 4GE SSM Media Type for Fiber Interfaces
(Optional)
Note
78-19186-01
Figure 15-2
Connecting the LC Connector
1
LC connector
Connect the other end of the LC connector to your network device.
e.
After you have attached any SFP ports to your network devices, you must also
change the media type setting for each SFP interface. Continue with the following
procedure,
"Setting the 4GE SSM Media Type for Fiber Interfaces
If you are using fiber interfaces, for each SFP interface you must change the
media type setting from the default setting (Ethernet) to Fiber Connector.
Because the default media type setting is Ethernet, you do not need to change the
media type setting for Ethernet interfaces you use.
Setting the 4GE SSM Media Type for Fiber Interfaces (Optional)
L N K
3
2
1
0
S P D
C is c o
S S M -4
G E
2
1
2
SFP module
Cisco ASA 5500 Series Getting Started Guide
(Optional)."
15-3