Cisco 5510 - ASA SSL / IPsec VPN Edition Getting Started Manual page 36

Connecting Interface Cables
a.
b.
c.
Figure 3-9
1
Step 3 Connect to the Console port.
a.
b.
Cisco ASA 5500 Series Getting Started Guide
3-14
Locate an Ethernet cable, which has an RJ-45 connector on each end.
Connect one RJ-45 connector to the Management0/0 port, as shown in
Figure 3-9.
Connect the other end of the Ethernet cable to the Ethernet port on your
computer or to your management network.
Connecting to the Management Port
1
LNK SPD LNK SPD
3 2
2
Management port
Before connecting a computer or terminal to any ports, check to determine the
baud rate of the serial port. The baud rate of the computer or terminal must
match the default baud rate (9600 baud) of the Console port of the adaptive
security appliance.
Set up the terminal as follows: 9600 baud (default), 8 data bits, no parity, 1 stop
bits, and Flow Control (FC) = Hardware.
Locate the serial console cable, which has an RJ-45 connector on one end and
a DB-9 connector on the other end for the serial port on your computer.
Chapter 3
LNK SPD LNK SPD
1 0
2
RJ-45 to RJ-45 Ethernet cable
Installing the ASA 5550
78-19186-01