Chapter 6
Connecting Interface Cables on the ASA 5500, ASA 5510, ASA 5520, and ASA 5540 Platforms
b.
c.
Note
Figure 6-1
1
Connect to the Console port.
Step 3
a.
78-19186-01
Connect one RJ-45 connector to the Management0/0 port, as shown in
Figure
6-1.
Connect the other end of the Ethernet cable to the Ethernet port on your
computer or to your management network.
When connecting a computer directly to the management port on the
adaptive security appliance, use a crossover Ethernet cable. When
connecting a computer to the adaptive security appliance through a hub or
switch, use a straight through Ethernet cable to connect the hub or switch
to the management port.
Connecting to the Management Port
1
LNK SPD
LNK SPD
3
2
2
Management port
Before connecting a computer or terminal to any ports, check to determine the
baud rate of the serial port. The baud rate must match the default baud rate
(9600 baud) of the Console port of the adaptive security appliance.
LNK SPD
LNK SPD
1
0
2
RJ-45 to RJ-45 Ethernet cable
Cisco ASA 5500 Series Getting Started Guide
Connecting Interface Cables
6-3