Configuring The Site-To-Site Vpn; Starting Asdm; Configuring The Security Appliance At The Local Site; Providing Information About The Remote Vpn Peer - Cisco 515E - PIX Restricted Bundle Getting Started Manual

Chapter 4 Scenario: Site-to-Site VPN Configuration

Configuring the Site-to-Site VPN

Starting ASDM

78-17645-01
This section describes how to use the ASDM VPN Wizard to configure the
security appliance for a site-to-site VPN.
This section includes the following topics:
• Starting ASDM, page 4-3
Configuring the Security Appliance at the Local Site, page 4-4
•
Providing Information About the Remote VPN Peer, page 4-6
•
Configuring the IKE Policy, page 4-7
•
Configuring IPsec Encryption and Authentication Parameters, page 4-9
•
Specifying Hosts and Networks, page 4-10
•
Viewing VPN Attributes and Completing the Wizard, page 4-11
•
The following sections provide detailed instructions for how to perform each
configuration step.
To run ASDM in a web browser, enter the factory default IP address in the address
field: https://192.168.1.1/admin/.
Remember to add the "s" in "https" or the connection fails. HTTPS
Note
(HTTP over SSL) provides a secure connection between your browser
and the security appliance.
The Main ASDM window appears.
Implementing the Site-to-Site Scenario
PIX 515E Security Appliance Getting Started Guide
4-3