Powering Up The Css; Powering Down The Css - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual

Powering Up the CSS

Powering Up the CSS

Powering Down the CSS

Cisco 11500 Series Content Services Switch Hardware Installation Guide
2-36
To power up a CSS:
• On an AC CSS, toggle the power switch to the 1 (on) position.
See Figure 2-11
–
– See Figure 2-12
See Figure 2-14
–
each power supply. Power on all of the supplies in the CSS. The AC OK
and DC OK LEDs light up on each power supply. If either LED remains
unlit, see the
this chapter.
• For a DC CSS, switch on the applicable circuit breakers for the power source.
Then on the CSS, toggle the power switch to the 1 (on) position.
– See Figure 2-13
See Figure 2-15
–
each power supply. Power on all of the supplies in the CSS. The I/P OK
and DC OK LEDs light up on each power supply. If either LED remains
unlit, see the
this chapter.
The CSS starts the boot process. For information concerning the boot process on
the Cisco 11500 series CSS, refer to the Cisco Content Services Switch
Administration Guide.
To shut down the CSS gracefully and avoid introducing lost or fragmented files,
always use the shutdown command prior to removing power from the CSS.
For example:
(config-boot)# shutdown
Once the CSS shuts down all processes, you can remove power from the CSS.
Chapter 2
for the location of the CSS 11501 AC power switch.
for the location of the CSS 11503 AC power switch.
for the location of the CSS 11506 AC power switch for
"Troubleshooting the CSS Power Supply"
for the location of the CSS 11503 DC power switch.
for the location of the CSS 11506 DC power switch for
"Troubleshooting the CSS Power Supply"
Cabling and Troubleshooting the CSS
section later in
section later in
78-13884-06