Tools And Supplies; Table 2-8 Tools And Supplies - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual

Chapter 2 Cabling and Troubleshooting the CSS

Tools and Supplies

78-13884-06
The accessory kit shipped with the CSS contains the following items used in this
procedure:
• One 2-hole grounding lug (Panduit no. LCD6-10A-L)
Two M5 screws for the grounding lug
•
Table 2-8 lists the other tools, equipment, and supplies that you need to connect
system ground to the chassis. These are items that you must supply.
Table 2-8 Tools and Supplies
Quantity Description
1 Number 2 Phillips screwdriver
1 Wire stripping tool
Varies Grounding wire
Varies Screws to attach ground wire to
grounding point at site
1 or 2 2-hole grounding lug. Lug must
fit 6 AWG stranded copper or
37/24 flex cables. Each lug must
have two holes, centered
0.625 in. (1.587 cm) apart, and
must accept M5 screws.
One lug is supplied by Cisco
Systems in the accessory kit. The
supplied lug is for the router end
of the ground wire. You may
wish to use a lug other than the
one supplied. If you need a lug
for the facility end of the ground
wire, you must supply it.
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Connecting the Chassis to Ground
Comments
—
Choose a tool that does not nick
the wire.
6 AWG, 0.204 in. (5.18 mm)
recommended. The wire should
have applicable agency
approvals such as Telcordia.
Part requirements depend on
location.
Recommended types:
Panduit no. LCD6-10A-L
•
(1 supplied in accessory
kit)
Panduit no. LCC6-10A-L
•
(long barrel)
• Thomas & Betts no.
256-30695-1183(*4*)
• Burndy no. YA6CL2TC10
2-23