Advertisement
Chapter 2
Installing the Cisco ONS 15530
SFPs with RJ-45 connectors require cabling after it is installed, and removal of cables is required before
Note
removing the SFP from the card.
Removing SFP Optics with MT-RJ Connectors
Note
You need the SFP extraction and cable installation and removal tool to remove the SFP with the MT-RJ
connector.
To remove an SFP with an MT-RJ connector from the ESCON aggregation card, follow these steps:
Remove the cable from the desired SFP.
Step 1
Remove the SFP from the module by pushing against the lever on the SFP to release it from the module.
Step 2
(See
OL-7706-01
Figure
2-17.)
Installing and Removing Line Cards or Motherboards
Cisco ONS 15530 Hardware Installation Guide
2-21
Advertisement
