Advertisement
Installing and Removing Line Cards or Motherboards
Figure 2-15
Step 5
Pull the SFP out and place it in a container appropriate for shipping and storage. (See
Figure 2-16
Tip
In an unlikely event of the pull-tab is damaged or missing, use a screwdriver to push on the hinge pin to
unlock the SFP cage latch and pull the SFP out from SFP port
Note
SFPs with RJ-45 connectors require cabling after it is installed, and removal of cables is required before
removing the SFP from the card.
Removing Non-Pull Tab SFPs with RJ-45 Connectors
To remove an SFP with an RJ-45 connector from the muxponder, follow these steps:
Step 1
Remove the cable from the desired SFP.
Step 2
Pull the latch on the SFP out. This releases the SFP from the latch lock of the cage.
Step 3
Pull the SFP out and place it in a container appropriate for shipping and storage.
Cisco ONS 15530 Hardware Installation Guide
2-20
Releasing the SFP
Removing the SFP
Chapter 2
Installing the Cisco ONS 15530
Figure
OL-7706-01
2-16.)
Advertisement
