Ssl Initiation Content Rule Quick Start; Table 2-9 Ssl Initiation Content Rule Quick Start - Cisco 11503 - CSS Content Services Switch Configuration Manual

SSL Initiation Content Rule Quick Start

Cisco Content Services Switch SSL Configuration Guide
2-20
If you configured an SSL initiation server entry in an SSL proxy list,
provides an overview of the steps required to create an SSL content rule for an
SSL initiation server.
Table 2-9 SSL Initiation Content Rule Quick Start
If necessary, create an owner.
1.
(config)# owner ssl_owner
Create owner <ssl_owner>, [y/n]: y
Add the SSL initiation back-end server to an SSL content rule.
2.
(config)# owner ssl_owner
(config-owner[ssl_owner])# content ssl_init_rule1
Create content <ssl_init_rule1>, [y/n]: y
Configure a virtual IP (VIP) address or domain name for the content rule.
3.
(config-owner-content[ssl_backend_rule1]# vip address 192.168.2.3
Specify a TCP port number for the content rule.
4.
(config-owner-content[ssl_backend_rule1]# port 80
(Optional) Enter the url command set to /* to use stickiness based on the
5.
cookie.
(config-owner-content[ssl_backend_rule1])# url "/*"
6. (Optional) Enter the advanced-balance arrowpoint-cookie command to
enable the content rule to be sticky based on an arrowpoint cookie.
(config-owner-content[ssl_backend_rule1])# advanced-balance
arrowpoint-cookie
Add the SSL service to the content rule.
7.
(config-owner-content[ssl_backend_rule1])# add service ssl_serv2
Activate the content rule.
8.
(config-owner-content[ssl_backend_rule1])# active
Save your configuration changes to the running configuration.
9.
# copy running-config startup-config
Chapter 2 SSL Configuration Quick Starts
Table 2-9
OL-5655-01