Cisco 11503 - CSS Content Services Switch Configuration Manual page 57

Chapter 2 SSL Configuration Quick Starts
Table 2-8
Task and Command Example
5.
6.
7.
8.
The following running-configuration example shows the results of entering the
commands in
!************************** SERVICE **************************
service ssl-serv2
OL-5655-01
SSL Initiation Service Quick Start (continued)
By default, the service keepalive type is ICMP. For SSL initiation, the keepalive
type can be ICMP, none, SSL, or TCP. If you specify either the SSL or TCP
keepalive, you must configure the port that the keepalive uses. The
keepalive port must match the SSL initiation back-end server port.
For example, to configure a keepalive type of SSL, enter:
(config-service[ssl_serv1])# keepalive type ssl
(config-service[ssl_serv1])# keepalive port 40443
Specify the slot in the CSS chassis where the SSL module designated for
SSL initiation resides.
(config-service[ssl_serv1])# slot 5
Add the SSL proxy list to the SSL service.
(config-service[ssl_serv1])# add ssl-proxy-list ssl_list1
Activate the SSL service.
(config-service[ssl_serv1])# active
Table 2-8.
type ssl-init
ip address 192.168.2.3
port 8080
slot 5
keepalive type ssl
keepalive port 40443
add ssl-proxy-list ssl_list1
active
Cisco Content Services Switch SSL Configuration Guide
2-19