Cisco 11503 - CSS Content Services Switch Configuration Manual page 55

Chapter 2 SSL Configuration Quick Starts
Table 2-7
Task and Command Example
11.
12.
13.
14.
15.
The following running-configuration example shows the results of entering the
commands in
server in
!************************** SERVICE **************************
service ssl-serv1
service ssl_serv2
!*************************** OWNER ***************************
owner ssl_owner
content ssl_backend_rule1
OL-5655-01
Back-End SSL Service and Content Rule Quick Start (continued)
Enter the advanced-balance arrowpoint-cookie command to enable the
content rule to be sticky based on an arrowpoint cookie.
(config-owner-content[ssl_backend_rule1])# advanced-balance
arrowpoint-cookie
(Optional) Enter the url command set to /* to use stickiness based on the cookie.
(config-owner-content[ssl_backend_rule1])# url "/*"
Add the SSL service to the content rule.
(config-owner-content[ssl_backend_rule1])# add service ssl_serv2
Activate the content rule.
(config-owner-content[ssl_backend_rule1])# active
Save your configuration changes to the running configuration.
# copy running-config startup-config
Table 2-7 in bold and the commands associated with the virtual SSL
Table 2-6.
type ssl-accel
slot 3
keepalive type none
add ssl-proxy-list ssl_list1
active
type ssl-accel-backend
ip address 192.168.4.4
port 8080
keepalive type ssl
keepalive port 443
add ssl-proxy-list ssl_list1
active
Cisco Content Services Switch SSL Configuration Guide
2-17