Creating An Ssl Service; Specifying The Ssl Acceleration Service Type - Cisco 11503 - CSS Content Services Switch Configuration Manual

Chapter 4 Configuring SSL Termination

Creating an SSL Service

Specifying the SSL Acceleration Service Type

OL-5655-01
When creating a service for use with an SSL module, you must identify it as an SSL
service for the CSS to recognize it. For additional details on creating a service, refer
to the Cisco Content Services Switch Content Load-Balancing Configuration
Guide.
Enter the SSL service name, from 1 to 31 characters.
To create service ssl_serv1, enter:
(config)# service ssl_serv1
Create service <ssl_serv1>, [y/n]: y
The CSS transitions into the newly created service mode.
(config-service[ssl_serv1])#
After you create the SSL service and the CSS enters into service mode, you must
specify ssl-accel as the service type to:
Configure the service as an SSL acceleration service.
•
Add the SSL proxy list to an SSL service.
•
Use the type command to specify the SSL acceleration service type. For details on
specifying an SSL service type, refer to the Cisco Content Services Switch
Content Load-Balancing Configuration Guide.
To specify the SSL acceleration service type, enter:
(config-service[ssl_serv1])# type ssl-accel
Configuring a Service for SSL Termination
Cisco Content Services Switch SSL Configuration Guide
4-49