Using The Wireless On/Off And Wps Buttons To Reset The Router - NETGEAR DGN2000 - Wireless Router Setup Manual

Using the Wireless On/Off and WPS Buttons to Reset the Router

To restore the factory default configuration settings without knowing the administration password
or IP address, you must press the Wireless On/Off and WPS buttons on the side panel of the router
simultaneously.
Press and hold the Wireless On/Off and WPS buttons until the Power LED blinks red (about
1.
6 seconds).
2. Release the Wireless On/Off and WPS buttons and wait for the router to reboot.The Power
LED will blink red three times and then will turn green when the default configuration settings
have been restored.
Troubleshooting 37