Table of Contents
Advertisement
N150 Wireless ADSL2+ Modem Router DGN1000 User Manual
Select Advanced > LAN Setup.
1.
Figure 47. Configure LAN IP services
Enter the LAN Setup configuration and click Apply to save your changes.
2.
IP Address. The LAN IP address of the wireless modem router.
IP Subnet Mask. The LAN subnet mask of the wireless modem router. Combined with
the IP address, the IP subnet mask allows a device to know which other addresses are
local to it, and which have to be reached through a gateway or wireless modem router.
RIP Direction. RIP allows a wireless modem router to exchange routing information with
other routers. The RIP Direction selection controls how the wireless modem router sends
and receives RIP packets. The default setting is Both.
When set to Both or Out Only, the wireless modem router broadcasts its routing table
•
periodically.
When set to Both or In Only, the wireless modem router incorporates the RIP
•
information that it receives.
When set to None, the wireless modem router does not send any RIP packets and
•
ignores any RIP packets received.
RIP Version. This controls the format and the broadcasting method of the RIP packets
that the wireless modem router sends. It recognizes both formats when receiving. By
default, this is set for RIP-1.
RIP-1. This version is universally supported. It is probably adequate for most
•
networks, unless you have an unusual network setup.
Chapter 6. Advanced Settings
| 75
Advertisement
Table of Contents
