Dell 7330 User Manual page 95

2. Insert the transparencies long-edge feed into Tray 1 (MPT) or Tray 6.
MAX
Tray 1 (MPT) Long-Edge Feed
Note:
Do not load paper above the fill line inside the tray.
3. Adjust the paper guides to the size of the transparencies if necessary.
4. If prompted on the control panel, press the OK button to accept the paper size and type
that are shown. If you have changed the paper size or type, do the following:
a. Select
Change setup
b.
Select
Transparency
c. Select the paper size, and then press the OK button to save your selection.
5. In the printer driver, select either Transparency as the paper type or the tray you loaded as
the paper source.
Printing Transparencies from Trays 2-5
1.
Fan the transparencies to release sheets that may stick together.
7330-142
, and then press the OK button.
, and then press the OK button.
Dell 7330 Mono Laser Printer
4-36
Printing on Specialty Media
Tray 6 Long-Edge Feed
7330-170
7330-118