Ipv6; Enabling Ipv6 - Dell 7330 User Manual

IPv6

This section includes:
■

Enabling IPv6

on page 3-25
Setting the Interface ID
■
■ Automatic Address Assignment
■ DHCPv6 on page 3-28
Manual Address Assignment
■
■ Address Precedence
Enabling IPv6
IPv6 can be enabled or disabled independently of IPv4.
Note: If you disable both IPv4 and IPv6, you will lose your connection to the printer. For
information on restoring the default TCP/IP settings, see
on page 3-26.
To enable/disable IPv6, use one of the following options:
■ The printer's control panel
■ Embedded Web Server
Using the Control Panel
To enable/disable IPv6 on the control panel:
1. Select
Printer Setup
2. Select
Connection Setup
3. Select
Network Setup
4. Select
TCP/IPv6 Setup
5. Select , and then press the OK button to switch between

IPv6

Using the Embedded Web Server
To enable/disable IPv6 using EWS:
1. Launch your web browser.
2.
Enter your printer's IP address in the browser's Address field.
3. Click Properties.
4. Select the Protocols folder on the left navigation panel, and then click TCP/IP.
5.
Click the TCP/IP (v6) button.
6. Select the TCP/IP v6 Enabled check box to enable TCP/IP v6.
7. Click the Save Changes button at the bottom of the page.
on page 3-26
on page 3-27
on page 3-29
on page 3-30
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
Dell 7330 Mono Laser Printer
3-25
Resetting the TCP/IP Configuration
and .
On Off
IPv6