Dhcpv6 - Dell 7330 User Manual

DHCPv6

DHCPv6 is used to acquire TCP/IP information.
The following DHCPv6 options are available in EWS:
As directed by the router - DHCPv6 is performed according to values in a router
■
advertisement. This is the default setting.
■ Always, for all configuration options (stateful) - Stateful DHCPv6 is always attempted,
and router flags related to how to perform DHCP are ignored. Configuration options and
an IPv6 address will be accepted if DHCPv6 is successful.
■ Always, for all configuration options except address (stateless) - Stateless DHCPv6 is
always attempted, and router flags related to how to perform DHCP will be ignored.
Configuration options will be accepted if DHCPv6 is successful, but no IPv6 address will
be assigned.
■ Never - DHCPv6 is not used even if directed to do so by a router.
To enable/disable automatic address assignment, use one of the following options:
The printer's control panel
■
■ Embedded Web Server
Setting DHCPv6 Options with the Control Panel
To change DHCPv6 options using the control panel:
1. Select
Printer Setup
2. Select
Connection Setup
3. Select
Network Setup
4. Select
TCP/IPv6 Setup
5. Select
DHCPv6 Mode
6. Select the DHCPv6 option, and then press the OK button.
Setting DHCPv6 Options Using the Embedded Web Server
To change DHCPv6 options using EWS:
1.
Launch your web browser.
2.
Enter your printer's IP address in the browser's Address field.
3.
Click Properties.
4.
Select the Protocols folder on the left navigation panel, and then click TCP/IP.
5.
Click the TCP/IP (v6) button.
6.
Select/deselect the DHCPv6 options.
7.
Click the Save Changes button at the bottom of the page.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
Dell 7330 Mono Laser Printer
3-28
IPv6