Unfused or Partially Fused Image
The printed image is not fully fused to the paper and easily rubs off.
Possible Causes
The paper may be damp.
Heavy or unusual paper may be in the tray.
The printer may be located in an environment
with extreme temperature or humidity.
The fuser may be defective.
Replace the paper.
Replace the paper with an approved paper type
then do the following:
On the control panel, select
■
Handling Setup
Configuration
Adjust the fuser setting for the paper type
■
selected.
Verify that the printer is located in an environment
with the temperature between 5° and 32° C
(41° and 89° F) and the relative humidity
between 15% and 85%. Move the printer to a
suitable area, away from air conditioning vents,
open loading docks, etc.
Replace the fuser.
Dell 7330 Mono Laser Printer
6-65
Print-Quality Problems
Solutions
Paper
Fuser
, and then select
.