4-6
Field Service Guidelines
4.
To replace the floppy drive unit, remove the four small screws attaching it to the
null floppy disk drive assembly and remove the floppy disk drive cable.
5.
To replace the floppy disk drive module, reverse the above procedure.
Removing/Replacing the LCD Status Bar Cover and Hinges
Remove the LCD Status Bar Cover and Hinge Covers are as follows:
Turn off the computer. Follow all disassembly procedures mentioned from the
1.
start of this section.
Slide the left and right hinge covers out to remove them.
2.
3.
Lift the status bar cover out.
4.
To replace the LCD Status Cover and Hinge Covers, reverse the removal proce-
dures mentioned above.
Removing/Replacing the Keyboard
The procedure for removing and replacing the keyboard is as follows:
Turn off the computer. Follow all disassembly procedures mentioned from the
1.
start of this section.
Lift the keyboard out and tilt the upper edge of the keyboard towards you, but do
2.
not lift the keyboard away. Rest the keyboard (face down) on the palm rest area.
Figure 4-2 Floppy Drive Module Assembly