Boot Setup Peripherals Menu; Boot Setup Security Menu - NEC Versa 2400 Series Service Manual

Item
Serial Port
Infrared Serial Port
Parallel Port
Parallel Mode
Diskette Controller
IDE Adapter
Item
Password
Set Password
Password on Boot
Password on Re-
sume
NOTE: You can discharge the CMOS battery by
simply unplugging the RTC CMOS battery from
the connector CN11 of the motherboard. You
must wait for 10 minutes before plugging in the
battery again.
Table 1-5 Boot Setup Peripherals Menu
Function
This option allows you to configure the notebook's serial port
as either (3F8-IRQ4), (2F8-IRQ3), (3E8-IRQ4), (2E8-IRQ3),
or none. The default setting is (3F8-IRQ4).
This option allows you to configure the notebook's infrared
serial port as either (3F8-IRQ4), (2F8-IRQ3), (3E8-IRQ4),
(2E8-IRQ3), or none. The default is (2F8-IRQ3).
This option allows you to configure the notebook's parallel
port as either (378-IRQ5), (3BC-IRQ7), (278-IRQ5), (378-
IRQ7), or none. The default is (378-IRQ7).
This option allows you to configure the notebook's parallel
mode as either Unidirectional, Bi-directional, Enhanced, or
ECP. The default is ECP.
This option allows you to disable the floppy disk controller.
This option allows you to disable the IDE adapter.
Table 1-6 Boot Setup Security Menu
Function
This option allows you to limit access to the computer through
the use of a password. If you select this option, a pop-up win-
dow will appear asking you to set or change the password. A
password can be up to seven characters in length, and is
cleared by eliminating the password with the F1 key.
Note: If you forget the password of the computer, the
only way to access the system again is to discharge the
CMOS battery. See note below.
Press <Enter> to enter the Password.
This option allows you to configure the Password to be en-
abled at the operating system level.
This option allows you to configure the Password to be en-
abled when resuming from the suspend mode.
The CapsLock and ScrollLock LED's will flash in sequence for
30 seconds, indicating that the password is required to re-
sume. The LED's will start flashing again as soon as a key is
hit until a password is entered.
Introduction 1-17