Removing/Replacing The Hard Disk Drive Module; Removing/Replacing The Floppy Disk Drive Module - NEC Versa 2400 Series Service Manual

Removing/Replacing the Hard Disk Drive Module

The procedure for removing and replacing the hard disk drive module is as follows:
1. Turn off the computer. Close the LCD cover and turn the whole unit over.
You will find a clamp latch (lock knob) that is securing the hard disk drive module
2.
to the system unit. To remove the hard disk drive module, push the lock knob
sideways with one hand and with the other hand pull the hard disk drive module
out. Note that this has to be done simultaneously.
To replace the hard disk drive, remove the four flat screws attaching it to the null
3.
hard disk assembly and remove the hard disk drive cable.
4. To replace the hard disk drive module, reverse the above procedure.

Removing/Replacing the Floppy Disk Drive Module

The procedure for removing and replacing the floppy disk drive is as follows:
1. Turn off the computer. Close the LCD cover and turn the whole unit over.
You will find a clamp latch (lock knob) that is securing the floppy disk drive
2.
module to the system unit. To remove the floppy disk drive module, push the lock
knob sideways with one hand and with the other hand pull the floppy disk drive
module out. Note that this has to be done simultaneously.
To replace the hard disk drive, remove the four flat screws attaching it to the null
3.
hard disk assembly and remove the hard disk drive cable.
Figure 4-1 Hard Drive Module Assembly
Field Service Guidelines 4-5