Makita GRU07T Instruction Manual page 15

Nylon cutting head
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
1. Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted. Remove the nut by turning it
clockwise with the box wrench.
1
Fig.14
► 1. Nut 2. Hex wrench
2. Remove the spool holder by pressing the claws.
Fig.15
► 1. Spool holder 2. Claw
3. Remove the spool from the spool holder by hold-
ing the nylon cord with your fingers and thumb, and
then hook both sides of the nylon cord to the notches of
the spool.
1
2
2
Fig.16
1
► 1. Spool 2. Spool holder 3. Notch
2
4.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Attach the spool holder to the
spindle, and then tighten the nut by turning it counter-
clockwise with the box wrench.
Fig.17
► 1. Nut 2. Spool holder 3. Hex wrench
NOTE: The recommended tightening torque is 20 to
30 N•m.
15 ENGLISH
1
2
3
3