Connecting/Disconnecting 5 " And - RIDGID K-750 Manual

Connecting/Disconnecting
Cable Couplings
Keep couplings clean and lubricated. Plunger pin must move freely and fully extend to secure connection.
New style – Plunger pin
Screwdriver required.
Connecting
1
1. Slide the couplings together. If needed, depress plunger
pin.
2. Confirm connection is secure. (plunger pin fully ex-
tended).
Disconnecting
1
2
1. Insert the screwdriver to depress the plunger pin.
2. Push the couplings apart until the male coupling con-
tacts the screwdriver.
3. Remove the screwdriver and push the couplings apart.
Figure 4
Attaching Front Guide Hose (Optional Accessory
For Use With AUTOFEED)
1. Pull approximately 4' of cable from the drum.
2. Slide Front Guide Hose over the cable, adapter end
first. Pull plunger pin head up and place adapter over
the mounting collar on the AUTOFEED. Make sure
plunger pin locks into the hole in the mounting collar.
278-104-411.10_REV F
5 / " and
8
2
3a 3b
K-750 Drain Cleaning Machine
3 / " Drum Machine
4
Old style – Rotating pin
Screwdriver required.
Connecting
Hash Mark
1. Slide the couplings together.
2. Rotate pin so hash mark is away from end of cable (to-
wards "L" stamped on coupling). Confirm connection is
secure.
Disconnecting
1. Rotate pin so hash mark is towards end of cable (away
from "L" stamped on coupling).
2. Push the couplings apart.
Plunger Pin
Guide Hose
Figure 5 – Attaching Front Guide Hose To AUTOFEED
Hole
7