Makita GA049G Instruction Manual page 14

For model other than 100 mm (4")
1
2
3
Fig.14
► 1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
1. Mount the rubber pad onto the spindle.
Fit the disc on the rubber pad and screw the sand-
2.
ing lock nut onto the spindle.
Hold the spindle with the shaft lock, and securely tighten
3.
the sanding lock nut clockwise with the lock nut wrench.
To remove the disc, follow the installation procedure in reverse.
Installing or removing Ezynut
Optional accessory
Only for tools with M14 spindle thread.
Mount inner flange, abrasive wheel and Ezynut onto the
spindle so that Makita Logo on Ezynut faces outside.
Fig.15
► 1. Ezynut 2. Abrasive wheel 3. Inner flange 4. Spindle
Press shaft lock firmly and tighten Ezynut by turning the
abrasive wheel clockwise as far as it turns.
1
Fig.16
► 1. Shaft lock
To loosen the Ezynut, turn the outside ring of Ezynut
counterclockwise.
NOTE: Ezynut can be loosened by hand as long
as the arrow points the notch. Otherwise a lock nut
wrench is required to loosen it. Insert one pin of the
wrench into a hole and turn Ezynut counterclockwise.
Fig.17
► 1. Arrow 2. Notch
1
2
Fig.18
3
4
14 ENGLISH
1
2