Installing Tuning Machines - Grizzly T33952 Owner's Manual

Lightly press down on decal with dampened
4.
fingers and slowly slide decal sheet from
underneath decal (see Figure 26).
Figure 26. Pressing decal flat to body.
When decal sheet is completely removed,
5.
lightly press on decal with a dry cloth to
remove excess water trapped underneath.
Let decal dry for at least eight hours.
6.
Installing Tuning
Machines
The supplied tuning machines are mirrored pairs:
three for the left side of the headstock, three for
the right. Each tuning machine consists of the
parts shown in Figure 27.
Note: Unless otherwise indicated, we strongly rec-
ommend using a drill press for drilling in this man-
ual to obtain the most precise results. However,
an electric/cordless drill fitted with a depth stop or
a drill stand can be used if you do not have a drill
press.
To install tuning machines:
Using a non-marring mallet, tap each of (6)
1.
machine seats with washers into pre-drilled
holes on front of headstock.
Note: Install tuners in pairs, from side to side.
Place a straight edge across tops of tuning
machines to ensure they are parallel
(see Figure 28).
Model T33952/53/54 (Mfd. Since 09/23)
From back of headstock, slide tuning
2.
machine posts through headstock and seat
(see Figure 27).
Headstock
Tuning
Machine
Screw
Figure 27. Tuning machine components.
Position tuning machine buttons to outside of
3.
headstock.
Set a straightedge across the top of each
4.
pair of machine tuners to ensure they
are parallel with each other from side to
side (see Figure 28).
Secure each tuning machine to headstock
5.
with (1) tuning machine screw, as shown in
Figure 28.
Checking
Machine
Tuner
Parallelism
from Side
to Side
Figure 28. Installing tuning machines.
Tuning Machine Seat
Tuning Machine
Washer
Tuning Machine Post
Tuning Machine
Button
x 6
-19-