Attaching Sound Hole Decal - Grizzly T33952 Owner's Manual

Place T-handle reamer in (1) bridge pin hole,
4.
and gently twist reamer clockwise, making
one complete revolution (see Figure 24).
Note: It is important not to take too much
material out of hole. Bridge pins should be
snug fitting.
T-Handle
Bridge Pin
Reamer
Figure 24. Reaming bridge pin hole.
Test fit bridge pin in reamed hole.
5.
— If bridge pin does go into hole and fits
snugly, fitting is complete. Proceed to
next hole.
— If bridge pin does not go into hole and
fit snugly, repeat Step 3.
Note: As you get closer to fitting bridge pin, it
may be advisable to only rotate reamer
turn. This will avoid removing too much mate-
rial and having bridge pins that fit too loosely.
-18-
Guitar
Hole
Body
Guitar
Neck
Bridge
Attaching Sound
Hole Decal
The sound hole decal decorates the guitar and is
easy to attach.
To attach sound hole decal:
Submerge decal sheet in water until decal
1.
slides around easily with finger pressure. This
usually only takes a few minutes.
Remove decal sheet (with decal) from water,
2.
letting excess water run off.
Gently slide decal off decal sheet into position
3.
around sound hole, as shown in Figure 25.
⁄
1
2
Figure 25. Sliding decal onto body.
Model T33952/53/54 (Mfd. Since 09/23)