Table of Contents
Advertisement
Attaching Fretboard
With the major components sanded completed
and the neck and truss rod installed, it is time for
the fretboard to be attached to the neck and body.
To attach fretboard:
Apply a thin layer of glue to back of fretboard
1.
and position it on neck.
Make sure fretboard is centered across width
2.
of neck and that 14th fret is positioned over
neck-to-body joint (see Figure 13).
Nut Position
Fretboard
Neck-to-Body
Joint
Guitar
Body
Figure 13. Fretboard correctly centered on neck.
-12-
Headstock
Top of Fretboard
14th Fret
Secure fretboard in place with C-clamps or
3.
rubber bands and wood stock, as shown in
Figure 14. Use wedges if necessary to
ensure a tight fit. Wipe off any glue overspill
with a damp, lint-free rag.
Figure 14. Fretboard secured to neck.
Let glue dry a minimum of 24 hours, then
4.
proceed to Step 5.
Use #320 grit sandpaper or a fine file to sand
5.
edge of neck flush with edge of fretboard. Do
this gently and slowly to avoid sanding
fretboard.
Model T33952/53/54 (Mfd. Since 09/23)
Advertisement
Table of Contents
